Hi I am taking apart my wii as per the instructions for my new case but I am having real trouble putting the DVD cable (not the ribbon cable) plug from the motherboard onto the plug on the DVD drive (as shown here: http://www.talismoon.com/multipage/p...ads/page-4.jpg ) - It just doesnt seem to go in at all, it goes in a tiny bit with the brass bits still showing but pops out as soon as I let go, it wont go all the way in

I've tried pushing it really hard, even using a screwdriver to push the little white plug very hard, but still nothing, I am worried I will break it if I try to force it too much too

Any suggestions please please, this is really annoying me it's pretty much the last problem before I can put the final top of the case on and play on my new wii (i bought the case and wii together but it came with default white one)

thanks for any help :S

It's the same bit as shown here, the second red-circled one on the right

Check for bent pins on board connector..........

cant really, its so tiny you can barely see the pins at all

UPDATE:

I have now found through looking REALLY REALLY REALLY close on the socket attached to the drive itself (not the plug, the plug seems to be fine) (i literally held it up to my nose and eyes trying to see inside the damn tiny socket, it probly looked hilarious it was on top of my nose... its really that tiny) that it is a case of bent pins, there seem to be some on the right hand side that are slightly bent towards the left, and there is also a black thing near the top



I found a better picture of the socket too, you can see clearly it's the cream/orange coloured bit on the right with the white plug in it:


how can I straighten these out safely without messing up anything else? even the smallest screwdriver I could find will NOT FIT IN IT to be able to push the pins back to the right

Firstly, don't panic. The more you force it out of desperation the more damage you may cause.

Try putting the cable in both ways, sometimes it is hard to see if it is the right way up or not.

Try using a pin to bend the contacts back into place.

If you have to ask this question, you shouldn't be taking apart your Wii.

Nintendo gave them special security screws for a reason. They're not made to be tinkered with by the consumer. They're put together by robots and meant to be serviced by people using specialized equipment that costs more than you and I make put together. Now you're in over your head and you've voided your warranty. That's the risk you accepted by deciding to open it up and mess around. Not all damage is fixable/reversible. It's quite possible you've caused irreparable, permanent damage.

Be prepared to buy a new Wii.

I know what you mean, but he came here asking for help. The least you could do is try to help him before telling him to give up.

And besides, if his Wii is irreparably broken, what has he got to lose by trying?

Because I see people break their electronics by opening them up all the time. Not just Wiis. Everyone seems to think that you can undo any damage if they just find the magical secret.

You can't.

Therefore, my theory is: they shouldn't be doing it to begin with.

Even with my bag of special-order tools there'd be a limited amount I could to. Every time you flex those pins, they weaken. If you can't bend them back perfectly on the first try, you're likely to break them clean off.

What casemod were you trying to install anyway deathkitty??

I have the solution!

at the ends of the conectors (mobo side), there is a large white tab, put the cable in the slot, then push that white tab back towards the connector

Frummage: